Takasy slot machine - wiring schematic

[jsider]

I have a Takasy slot machine. The problem I'm having with it is similar to the one in this thread:

http://www.pachitalk.com/forums/show...nt-Parts/page2

The game powers up and runs, but the stop reel buttons don't work (the reels eventually time out and stop). With mine, I'm not getting 24v at the small board that controls this. All the fuses are good and the wiring is good. Already reflowed the solder joints on most of the connectors. Is there a wiring schematic available for these so I can see exactly where the 24v is coming off the power supply?

[Moparformances]

no schematics for these machines exist that we know of.. if they do no one is sharing..

Welcome to Pachitalk

[Mattster]

Hello I am new to this platform so forgive me if i act out of line. I have a Baltec Touchdown Pachislo machine and looking for wiring diagram for the mother board. I have rebuilt the reel stop board and my power supply is working fine. I have ac for lights but can't find the 24 v dc. Any thoughts. Or is there a co that will rebuild it for me?

[rockston]

Welcome, please read the answer above you. The manufacturers don't release the schematics
of present or past gambling devices for obvious reasons. The only 24VDC needed is usually
for the coin hopper motor. The mother board runs on +5 -5 DC.

[Mattster]

My machine is a Baltec Touchdown machine and is it rare?

[rockston]

Why don't you upload some pics of the front, I don't see that lsited in the database.

[Mattster]

1000000719.jpg1000000907.jpg

Why don't you upload some pics of the front, I don't see that lsited in the database.

[rockston]

Looks like a 1991 Frame it may be somewhat rare to have one in the USA but that doesn't mean it's
valuable. What's the problem with it?

[Mattster]

at doesn't mean it's
valuable. What's the problem with it?[/QUOTE]

[Mattster]

Not sure I need to see where power goes through mother board. Machine won't come on. I have not replaced caps on it yet.

[rockston]

Not sure I need to see where power goes through mother board. Machine won't come on. I have not replaced caps on it yet.

Should be a cable from the power supply to it.

[Mattster]

I had a friend check power supply and all is as it should be. When I turn machine power on I have no signs of life. The two things i have noticed is that the fuse on the reel stop board blows immediately, I hear a crackle from the speaker. One of the caps on the logic board is slightly bulged up. This is an old friends machine it just makes me want to bring is back to life. Also they are fun to play. I would love to get the logic board fixed or replaced but I know it would be easier to just get a working machine.

[takethecastle57]

and biscuits



To jsider


And to Mattster

[Mattster]

I think i am going to start chasing traces to the first components and maybe i can id the voltage from the components

[Drunkenclam]

blown fuse on the reel stop board is normally a sign you need to replace the caps on that board.

[Mattster]

I rebuilt two boards and the mother board is still blowing fuses and now I have no lights. I think the mother board went out. Boat anchor!

[Mattster]

[QUOTE=Mattster;656916]I rebuilt two boards and the mother board is still blowing fuses

[Mattster]

20250502_144216.jpg

[Mattster]

This is an ultraman club how do I reset there is no key?

[MrGneiss]

Do you have no door key or no reset key??

If it's the reset key you're missing, then most people replace the key switch with a simple on/off switch!!