Super Bingo volume location?

[Bullwinkle]

Hey gang, I've got a Super Bingo machine that I recently purchased for the family, and I can't find any volume control switch on this one. My Neo Magic Pulsar has a round switch at the top right behind the door. On this model I don't see one anywhere. Who's got one that can share this secret? I realize I should put a volume control on it, just curious to see where it is currently set. Thanks!

[luckydog]

follow speaker wires to the amp, the switch should be somewhere on the amp,

it may be under the plastic amp cover with an access hole for adjusting.

[RaymondV]

The volume controls are 2 - 3 position switches located on the board to the left of the reels.
They do not do much, even on low it is still pretty loud.
I can post a pic if you need it

[Ichi]

The volume controls are 2 - 3 position switches located on the board to the left of the reels.
They do not do much, even on low it is still pretty loud.
I can post a pic if you need it

I know this is an old post, but please post a picture of where I can adjust the volume on this machine!!! Its too loud for my apartment lol. Thanks!

EDIT: I found the manual from GAC. http://www.gaktradinginc.com/01home/...superbingo.pdf on the fourth page it has a pic of the volume controllers, which way to i slide them to make it quieter?

[luckydog]

slide it one way and drop in a token, them slid it the other way and do the same, you will be able to tell that way.

cotton balls in between the grill and speakers are a temp fix if too loud.

[Ichi]

That you so much! I also found how to unhook the speakers if necessary if anyone is interested. :-P

[new in town]

:compdeskON'T disconnect the Speakers and play the machine!!!:compdesk:

Without a load from the Speakers to the amp you will risk Blowing the final output section of the amplifier. You need to install volume controls or at least a 68 Ohm resister on each Speaker.

[Ichi]

:compdeskON'T disconnect the Speakers and play the machine!!!:compdesk:

Without a load from the Speakers to the amp you will risk Blowing the final output section of the amplifier. You need to install volume controls or at least a 68 Ohm resister on each Speaker.

Its still safe to stuff cotton balls in between the back of the face of the machine and the speaker though right?

[new in town]

YEP ! ! !

[Ichi]

Awesome, thanks so much.

[new in town]

U R Welcome.