need help SR-Z nishiji

[jinxy]

The rotary motor that flips the launcher is not rotating at full power...when it spins around it makes contact with the launcher but does not give it enough power to launch the balls all the way up the shoot...do I need a new motor or if it wiring issue? Please get back to me. This is my first restoration and I am extremely exited to get it up and running

[luckydog]

some pictures might help

[Moparformances]

your post is in the Arrangeball section.. im guessing you have a mordern Pachinko??

if you could post a picture or two im sure we can get ya headin in the right direction... and of course

Welcome to Pachitalk

[jinxy]

20140629_121922.jpg20140629_121826.jpg20140629_121816.jpg20140629_121729.jpg

[jinxy]

Also the motor sometimes seizes up. it will stop rotating as if it does not have enough power,,,than it will start again

[emmadog]

May just need to be disassembled and cleaned??? Take plenty of pics.

[Drunkenclam]

西陣 もちあげ隊
Nishijin - Corps - 1990

Might be worth just checking your power supply / transformer is ok, Test the motor out of the machine. and see if thats ok, Finding an exact motor would be hard, But others have managed to install after market generic motors in their place. But it wouldn;t be a simple plug and play. Of course it could be the teeth have worn out in the gearbox, or the rest of the shooter gunked up. Does the part that the cam pushes against move freely against the spring? But start at the basics, 24 vac in and a stable supply to the motor.

[jinxy]

I will take it apart and see what is going on in the inside...yes i have tested the motor out of the machine it sometimes starts and does not start. so it may be something internal.

[jinxy]

I will take apart the motor and see what is going on inside. plus I will check the pathway of the launched balls to make sure it is not plugged...thank you soooooo much for the feedback I will get back to you once I do all these things