Does this look right Nishijen Model B "derby"

[Mcrowell75]

I foolishly did not take a picture of the ramps or the tulips when I disassembled my machine. This is my best guess. Can anyone here confirm that I have it right.

Thanks for looking!

IMG_2754.jpg

[Wayne-Ooo]

I would say that is wrong.

Lay your pieces out separately and post a picture of them. Are some of them attached to the red plastic?
Also a picture of the board, with no pieces on it, then I can photo shop you a picture of how they go, once I see the picture of all the separate pieces.

[Mcrowell75]

The large piece has the red plastic attached. I never separated it during disassembly. Here are the pics. Please check my tulips too. I may have them swapped.

Thanks again Wayne!


IMG_2756.jpgIMG_2755.jpg

[Wayne-Ooo]

Well, I wasn't expecting all those pieces were attached to the red plastic. So, I'm really not sure.

Normally, you can go by the fading on the board, were the plastic was and by the staple holes in the pieces.

Those longer pieces you have on the sides of the tulips shouldn't be there, they should angle down from each side tulip to the center tulip, again check the staple holes in the pieces to the staple holes in the playfield.

Normally, the ball exits the tulip towards the center of the playfield.

[Mcrowell75]

Here is the final draft... I hope. After swapping the tulips, I took a step back and was able to see the old fading and the staple holes all lined up.

The ramps should be correct now. Thanks for the tips Wayne!

IMG_2757.jpg