Power set up Sanyo 1972 comet II

[Sherlock]

Recently pick up Sanyo Comet II. Would like to restore wiring not sure where to start. I have done some rewiring on a Nishijin machine this is my first Sanyo .

There is a loose red wire not sure if this broke off the board. Not sure where to in my black red cables from my 9 volt supply.

Any assistance would be appreciated.






Sent from my iPhone using Tapatalk

[takethecastle57]

and biscuits


One of our members who have/had this model will be by shortly to help you .

[rockmike]

molex match 3 3 pin wire connector on amazon

[Sherlock]

molex match 3 3 pin wire connector on amazon

Any idea where the free red wire goes. Do you think it needs to be soldered back on the pc board somewhere


Sent from my iPhone using Tapatalk

[Pbenja3028]

I posted this a while back about the p/n’s for the matching Molex connectors:

Sanyo Comet-II: Molex still makes original power supply connectors
https://r.tapatalk.com/shareLink/top...ink_source=app


Sent from my iPhone using Tapatalk

[Pbenja3028]

Here's a pinout of all of the connections on the PC Board for a Sanyo Comet II. On the flip side of the board (not shown),
the two single pin connectors (with blue wires attached) go to the Jackpot Leaf Switch.

PC Board Connections.jpg

[Pbenja3028]

Also, I forgot to note that only two of the three connector pins are used (shown on the pic as +9V and (-).
Hope this helps!