3D Part Repository

[SibSr]

Nishijin B Payoff Leaf Switch

This switch is mounted to the right of center with 2 orange wires going to it. The long switch leaf is contacted by a wire attached to the payoff linkage arm. The bottom long leaf is raised to contact the short leaf and complete the circuit.

originalswitchinplace.jpg Here is the original switch in position and is operated by upward movement of the payoff arm.

Here is my switch in place newswitchinplace.jpg.

I add 12" of wire leads to the switch so they reach the connection points. The switch body is just a long rectangular tube with a rear exit for the wires, and midline mounting tabs.
Nishikinpayoffswitchbottom.jpg Nishikinpayoffswitchtop.jpg

Printer = Ender3 Pro V2
Material = PLA or PETG
Infill = default setting
Supports = Yes (tree)
Build plate adhesion = Raft
Print Speed = 50mm/sec
Print head and bed temps are set per material used.