Machine not taking coins.

[ForgiveR]

You appear to have some wire bundles terminating in the wrong places.

Please see the image below, from my Neo Magic Pulsar.

I believe you need to swap your connections on CN1 and CN3. Give that a shot and retest!

[ForgiveR]

Also re: you comment that "The CN3 appears to connect nowhere, where should it be inserted into?" That component should be connected to CN1, and is the "reset sensor" which is merely mounted directly below CN1. You can see that in my image.

Hope this helps!

[dmmen]

Hey! Thanks for your answer. Sadly I still ecountered some problems:

Before rewiring I did another reset, and I got the E-0 (apparently the resoldering wasn't all of the problem).
Did the rewiring (as you can see below), another reset and got the same error, so... what could be wrong with the machine?

IMG_4930.jpg

P.S. I see from your photo that mine is lacking the transparent plastic coin taker, could that be one of the problems? As far as I tested, mine does not have problems taking the coin from the slot, but they go to the tray once they reach the enlongated "hole" behind the component that has the red sticker (below CN4, let's say).

[dmmen]

Also re: you comment that "The CN3 appears to connect nowhere, where should it be inserted into?" That component should be connected to CN1, and is the "reset sensor" which is merely mounted directly below CN1. You can see that in my image.

Hope this helps!

Hey! Thanks for your answer. Sadly I still ecountered some problems:

Before rewiring I did another reset, and I got the E-0 (apparently the resoldering wasn't all of the problem).
Did the rewiring (as you can see below), another reset and got the same error, so... what could be wrong with the machine?



P.S. I see from your photo that mine is lacking the transparent plastic coin taker, could that be one of the problems? As far as I tested, mine does not have problems taking the coin from the slot, but they go to the tray once they reach the enlongated "hole" behind the component that has the red sticker (below CN4, let's say).