Re: Noobie Looking for advice
The see saw reset is triggered mechanically by the weight of the pachinko balls pushing down the big lever.
Because some of your pachinko balls are falling out, it is wacky.
The Sanyo Comet II commonly has the same problem caused by something else. Som folks call it the sticky see saw issue.
On your Mizuho, I'd take a piece of plexiglass and hold it over the back. If possible, mark and pre-drill holes to line up with the existing screw holes. Then cut the plexi to fit. Use screws (in existing holes) and washers to hold in place.
Reply With Quote
