Sammy Aladdin II, reels will spin but I can't get them to stop?

**BR549AUTOSALES** · 02-23-2014, 07:16 PM

I do not really know much about these machines but it will accept the tokens and will spin when I push the handle down but the reels will not stop by pressing the buttons, they will eventually stop after they time out, @ 1 min. or so onece they start spinning. I did notice that a fuse was missing from a board inside the machine, I will include a pic of that board. Any ideas what I can do to fix this?

Thanks!

**luckydog** · 02-23-2014, 07:27 PM

try reseating all your connections to the buttons

**BR549AUTOSALES** · 02-23-2014, 09:08 PM

I have re seated every connector inside the game so far with no results, what's weird is when I put the fuse in on the reel stop board, the game won't power up.

**heima** · 02-24-2014, 01:22 AM

Originally Posted by BR549AUTOSALES

I have re seated every connector inside the game so far with no results, what's weird is when I put the fuse in on the reel stop board, the game won't power up.

And if you pull the fuse out, the game will power up? If so, that is weird. Are the connectors correctly attached to the reel stop board? None reversed? None shifted a pin or two?

Have you tried a full reset? While power on, turn keyswitch on power supply clockwise. Remove power by pulling plug from outlet. Put plug back into outlet. Pull down on reel spin knob. Turn keyswitch on power supply counter clockwise.

**BR549AUTOSALES** · 02-24-2014, 01:29 AM

The lock, which I guess is for the key switch does not have any wires going to the back of it, so I guess it's been disabled? Is there another way to perform a full reset since that lock is not a switch any more? I will check the connections on the reel stop board again. Thanks for the response.