2 Hanemonos $9.99 ea Start!!

[MrGneiss]

Here are two hanes being sold by Seattle Goodwill on ebay..One looks ok the other in pieces, but it looks like the have most of it..

Still, for $10 I'd buy them if they were here..

Pick up only..
$(KGrHqVHJ!8E63SLiGFDBO0s6LKq2!~~60_3.jpg$(KGrHqRHJDME63ZMVcgsBO0s4z4UO!~~60_3.jpg

Nishijin Semi-Automatic Pachinko Machine for Repair/Parts Rock LOCAL PICKUP ONLY | eBay

Nishijin Semi-Automatic Pachinko Machine for Repair/Parts Fall LOCAL PICKUP ONLY | eBay

[WondersPachi]

MG your profiles avatar history leading up to this is hilarious! You planned this didn't you!

Great Job!

[MrGneiss]

I'm glad you liked it, I've been doing that for Thanksgiving for a few years now..

[MrGneiss]

Yay, they both finally have one bid!!

I was afraid no one would rescue them..

[owennewton]

I was going to wait for the last moment and try for them both at the opening bid (gas would cost me what they are worth)

[MrGneiss]

They went for $42.50 and $27.50!!

[WondersPachi]

Did someone here get em?! If they did and have problems with em let me know! I just got that Napalm machine from orlando this wekend (I'll be doing a write-up) but when I plugged it in there were these two gears that were buggin out!! like "BRRRR!!! BRRRRR!! BBBRRTTT!! BRT! BBBRRRRR!!" from when you plugged it in until you unplugged it. I was thinkin CRAP did i just buy a broken machine but no! with a little Hmmm and a bit of hermmmmm I got Vuala! The thing is the machine ALWAYS has to have Peebs in the reward hopper or it will bug and you have to remove a back panel under an electronics box where you have to have two pins line up so it holds the payout "see-saw" (upper pin) up and the actual pachinko ball payout mechanism pin (lower pin) inside the lower gears track. If you look closely at them they have two white dots on both gears. In correct positioning they will be pointed to each other. Since the gears are linked together you just match up the marks and make sure the see-saw's sensor arm is in the sensor (which it will have to be if you get the see-saws pin resting ontop the upper gears little "pusher setup" when yuo re-assemble it).

After getting that panel on right and the see-saw being UP the gears now spin once after each payout ball is recieve into the see-saw. Perfect.