Pulsar Big Chance 7777

[ruesterdog]

I just purchased a Pulsar Big Chance 777. For the most part everything works. But, the flourescent lights flicker and the 1,2,3, lights on the left hand side dim every once in a while. I measured the voltage acoss the 1,2, and 3 lights when the are dim and found them to be around 10 volts instead of 21 volts when they're bright. Does anyone have any ideas on the cuase? A bad power supply?

[luckydog]

most likly a poor connection somewhere in your wiring, which is a common problem

unplug and reseating wires usually fixed that

[Moparformances]

Welcome to Pachitalk

[ruesterdog]

most likly a poor connection somewhere in your wiring, which is a common problemunplug and reseating wires usually fixed that

I tried reseating the cables with no luck. *But I did notice the fluorescent light stopped flickering when I disconnected the yellow cable to the 1,2,3 lights. *Do you have any ideas that would cause that? *Do you know if I get schematics? *Thanks in advance for all your help. *Sent from my iPhoneOn Aug 21, 2011, at 5:36 PM,



I tried reseating the cables with no luck. But I did find that when the fluorescent lights were flickering, I disconnected the yellow cable from the 1,2,3 display board and the flickering stopped. Do you have any idea why that would happen. How can I get schematics? Thanks in advance for your help.

[yose]

It could be a loose ground wire or a pinched wire on the door by the hinges.And welcome to pachitalk

[SlotsRfun]

You need a wiring diagram or another machine to compare it to.
if the flicker stops when the yellow wire is disconnected I would leave it that way.
Like Yose said, check for loose wires or if they are getting pinched when you close the door.

Anyone have a wiring diagram for this machine?