Re: Custom Ball Lifter (with worm method)
P1010297.jpgP1010298.jpgP1010300.jpg
First important fix. I discovered the balls goes too deep inside inlet part. A small copper wire prevent it.
When ball goes too deep, it might block the lift.
P1010302.jpgP1010303.jpg
Second fix. Sanded down the sharp ends. This prevent also blocking by balls and it can makes sometimes "slam" sounds if sharp end hits ball at bad time.
The balls roll now much smoother inside after fix.
P1010304.jpgP1010305.jpg
Finally many problems are solved and the lift runs much better in latest tests.
The project is finished for main goal.
I show you now some youtube clips.
Security part demonstration.
Two videos are still in upload, but you may react. This is last story post.
Reply With Quote
