Lazy reels

[teqkng]

I have a unit that does not stop the reels where it should. A couple of the characters show up a half space to an entire space lower than they should, it is not the step motors as the issue duplicates the space not the placement of the motors. Anyone know of an adjustment that is eluding
me???

Martin

[FTKServices]

If they are always showing up at the same place out of alignment. It is possible that the reels have been removed & put on 180 degrees out or atleast one one screw position.
Hope this helps.

[teqkng]

Nope I have tried quite a bit, Adjusting the reels on the Step Motors etc. this picture shows the situation, this is the unit with 3 bunches of grapes registering as a win on the center line. Anyone?
juggler1.jpg

[Youngjedi]

remove the plastic symbol strips and re-apply in the correct position. Put a piece of tape and mark where the start of the strip is on the reel first.

[luckydog]

thats a common problem if its a Bellco machine.

I've seem a lot like that.

[teqkng]

this is an original Jugler machine, in perfect condition except for the paint below the third reel...

I will likely fix and restore it to either play with or prize out at a casino party... like the one you see as my Avatar, this party actually had 8 blackjack tables, 3 roulette wheels, 2 craps tables, wheel of fortune, and 5 poker tables.

the one before this one was 12 machines at Mar-a-lago for the bootleggers ball. I think I will start posting the memorabilia from these shows here...

To bad about not getting to go to California, the production company I work with is doing a night at "The Mansion" Hef and the bunnies. I would have loved to get a dozen or so of the new playboy pieces on loan for this one. would have driven the cost for the units used well over a grand each.

[teqkng]

thanks will try