.99 cent INDIANA JONES

[fronzdan]

That's one of the drawbacks of the current prices. It's a shame it costs so damn much to ship from Japan.

YJ...I'll check on my Indy after work.

[METZ]

but those are for brand NEW right arby?
so I dont think its all that bad of a price

[arbycoffee]

but those are for brand NEW right arby?
so I dont think its all that bad of a price

Brand new in comparied to that they were setup in use at factory to adjust the nails, but not installed in a shop. But some have been used in demos at time.

[fronzdan]

The advantage of bulbs, is that they are easily replaceable. There is one are that I cannot tell if there is a bulb...maybe aomeone can help. Here it is...

On the lower left of the cell, There are three holes in a gold area. When a ball falls through the Flipper sensor, the left on lights up. Another ball, the middle one lights up. The third one on the right, never lights up and I'm thinking it should. Does anyone with an Indy have this same look to theres? Please let me know if I should have three lights after three go through the sensor.

YJ, my machine does the same thing. The bluish green gem above Indy in the mine car is not normally lit. It MIGHT light during a fever, I don't recall. It kind of doesn't look like there's a bulb behind there though. As for the three holes in the gold area, only the first two light as a result of the sensor seeing a ball. I don't think there's an actual light by the third hole.

[Youngjedi]

I took an inventory of the bulbs that are needed for my Indaiana Jones I got from PanchinkoCasino.:
6 Blue cap
3 red cap

They are the bulbs accross the top of the Lumina Frame. I Switched them with my Star Wars to confirm that is was the bulbs.

PanchinkoCasino is supposed to call to help set me up with new bulbs, but I have a question...

For the Future, Where is a good source for these types of bulbs? The Bulbs seems special because it has a rubber top on it for color and are fastened to the twist base.

Thanks

[slotter]

The blue rubber part can be pulled off and put on another bulb. Take that blue "condom" rubber thingie off the bad bulb and save it to put on a new one.

[dattia]

Tulsa suggested that I call Syscom to ask about a replacement for a bulb on my Lumina Frame. I will do so today.

[Youngjedi]

Dattia,

How did you fare with Syscom (i am assuming american syscom)?

After reading your post, I thought it a good idea to get extra bulbs, so I e-mailed tham. They said that they did not carry any bulbs for Pachinkos.

Is there another Syscom?

Thanks in advance,

Youngjedi

[dattia]

Sorry, I did not get around to calling them. I guess I will call Panchinko then, that is where I bought Julie.

[Youngjedi]

Pachinko Who?

[dattia]

They are the couterpart to samuraislots...I think they may have changed their name a few times. I'll have to check ebay to see what they are going by now.

[Youngjedi]

Is it PanchinkoCasino? That is where I got my Indy with the 8 bulbs that don't work.

They said they would call, but I have not heard from them yet.

[dattia]

Yes, they are the same.

[slotter]

I'm surprised you didn't go to Panchinko or CF Exports right off the bat, Dawn? Since this bulb was likely out when you received the machine, they might even replace it for free. What was the warrranty period when your machine was bought? The warranty has recently been shortened a bit, but you might still be covered...

[dattia]

Well Slotter, I guess the real truth is that it really doesn't bother me too much...I didn't even notice it, until it was pointed out to me When American Syscom was mentioned, I thought I would go that route and order extras, as I had ordered my volume controls from them recently. Since that appears to be a dead-end now, I will call Panchinko. I don't know when I purchased it, although I could get the information by searching this forum. I don't even have the invoice with any info...I throw silly things like that in the trash

[slotter]

It doesn't bother you??? I'm hoping they just take care of you, Dawn. Just tell them you didn't notice it until a "friend" pointed it out to you. They very well might!

As mentioned, my machine came with a bulb out and I talked to Jake, he sent one, and strangely it did not work! I called him again and requested another which he sent right out.

[birdbrain]

you bought it the morning of 28 October