Daiichi missing piece need help

[Mrtoad]

Hello,

i am am just trying to finish off my Daiichi and when reading other Daiichi posts I realized I am missing a piece. I am not sure though what the piece does or if anybody has I could try to purchase or could try to make something if I knew what it does or how it works. Here is a link to the post where Carl mentions where the part goes but not sure if it is a stationary part, or moves and what it even does. It is the part Carl says goes where the blue line is.

If Carl or anybody else can help, I appreciate it.


http://www.pachitalk.com/forums/show...l=1#post543215

Thanks,
Mike

[Tink]

That part is stationary, directs the winning balls from the payout toward the payout ramp. You could probably fabricate something to fit. Just needs to change the ball direction down the ramp rather than a straight fall.

[CarlW]

Will look for those parts later today...

[Mrtoad]

Thank you both. Carl if you have one I would gladly buy it, thank you. If not I will figure something out. I appreciate the help!

[Gmwd]

Which part are we talking about. If mine has it I'll pull my daichi apart and print you one

[Mrtoad]

That would be fantastic, thank you. If you look at the link I posted you can see a picture of it not installed and then where Carl mentions it should go. It goes in the top of the back just below the jackpot. He said it is connected with a nail that goes through the piece and the plastic back. Please let me know you think the cost would be. You can PM me. Thank you for the offer, I appreciate it!
Mike

[Gmwd]

Mine doesn't appear to have that piece? If anybody could post measurements I cans till print one (or if Im being daft and overlooking it please let me know lol)

[Mrtoad]

Mine doesn't appear to have that piece? If anybody could post measurements I cans till print one (or if Im being daft and overlooking it please let me know lol)

if you take off the cover over the jackpot it might be right below it inside the cover that is directly below the jackpot. If you don't have it or if nobody has one to give measurements it is ok though, I am sure I can make something that will work. I was thinking of maybe a small hinge with something flat attached to it and can run the nail through where the hinge pin would be. I appreciate you trying either way. Thank you!
Mike

[Gmwd]

I'll pull the cover in the morning and let you know

[Mrtoad]

Awesome thank you. I do appreciate it!

[Gmwd]

I'm with ya now. You just need the little dump tray slide mabober :-) lol

i can print that out of a tough plastic if that will work for you. Pm me where to ship it.

[Mrtoad]

Yes that is the one and the proper name for it..

thank you very much, I will pm you now.

[Gmwd]

So i inally got a minute to print. MR toad pm sent your waym. Anyone else needing one here is what i came up with. Few hours of play in and all seems ok20160903_114311.jpg

[Mrtoad]

So i inally got a minute to print. MR toad pm sent your waym. Anyone else needing one here is what i came up with. Few hours of play in and all seems ok20160903_114311.jpg

Awesome, thank you so much!

[Gmwd]

20160905_174719.jpg

A installed picture.

[mxfaiman]

@Gmwd

It'd be awesome if you'd be willing to add your STL file to the 3D printed parts thread I made a while ago.

http://www.pachitalk.com/forums/vint...nko-parts.html

[Gmwd]

Absolutley! Ill try to remember to throw it on there tomorrow! Thanks for the link!