Re: Royal Ace CR error wont clear
Holy crap I got it working! I took the coin mech from the board it was plugged into (after turning power OFF!), cleaned it out even though it already looked pretty clean considering its a 26 year old Machine. Plugged it back in, did a reset by turning the key and holding the button next to the key to also change odds (I think this might trigger a "Full" reset?), and held the joystick down for a good 15-20 seconds. Then turned the key and immediately heard the click of the electromagnet on the coin mech turn on. And everything works! Good luck hope you get yours going too!
I also put some conductive grease on the pins of the coin mech plug. Not sure what fixed it this time because along with unplugging and cleaning the coin mech, I also made sure to hold down the arm for a good 15-20 seconds this time. There was no indicator when doing this that anything happened but when I turned the key back up the machine initialized. So I wonder if I just wasnt doing the reset correctly before because the sticker in my machine just says "depress arm" in the reset steps, not to hold it down for 15+ seconds which I read in another thread.
Anyway good luck!
Reply With Quote
