A Cabinet for Fujiko
I decided it was time to make a cabinet yesterday for my Fujiko pachinko, the factory hopper on this one is hopelessly small, also it wasn’t as stable as I’d like with just basic “feet” attached as it’s stand. It felt too “tippy” (this one has a huge front heavy frame) so I whipped up this cabinet with some extra 1”x8”s and a 1”x12” board for the base using my trusty Kreg pocket hole jig.
As you can see, I added the extra hopper and kept it as a basic tabletop design with rear access ball catcher tray, which works fine for my current setup on a bar height table (don’t want to make it any taller than it already is)
Turned out pretty decent! I ordered a few Fujiko stickers to customize it a bit to be added at a later date.
Reply With Quote
