This is my second try out for a single ball cycle system. By using a Tupperware Bowl above the the ball lifter with a 1 and half inch hole in it. So the balls will not over flow the ball lift sides, because the way they stack. This allows you to hold more balls, so as you loose them to the machine. They stack up for when you go into Fever Rounds. You still need to empty the front trays as you win, just like in a real Pachinko Parlor.

Parts list:
1) 14” x 20 3/4” x 3/8” one side good
2) 1” x 6” x 14” no. 2 Pine
3) 1” x 4” x 12” no. 2 Pine (1 piece is under the Ball Lifter)
a hand full of 1 1/4” dry wall screws
Tupperware Bowl 3” tall x 10” long X 6” wide (Drill a 1.5” hole off center)

Ball System 2 #1
Ball System 2 #2