My take on a pachinko wall
I'm working on something similar to what Denhomer is doing. His pages are here and here
So far I have picked up eight 8ft 2x4s, cut each to 56" 19" and 17" with a teeny bit of scrap left over. Then pocketholed the 19" and 17" ones, screwed them into the 56" ones and called it done for now. Trying to decide if I want to put the pachinkos on top as stand alone pachinkos each in their own frame, or if I want to go frameless and attach the pachinkos directly to the base.
Also not sure yet if I'm going to do a ball mover and get the card readers, or just leave them the way they are with manual ball lifts and drawers... or a ramp to put the balls down at one end. I've spent less than a day cutting/drilling/gluing/claming/fastening. Quite a bit less than a day if you subtract out the time I spent looking for where I left my cordless drill or trying to locate the chuck key for the corded drill.
PachiWall00Plans1.jpgPachiWall01.jpgPachiWall02_11ft7inWide.jpgPachiWall03_20in_from_floor.jpgPachiWall04_26in_front_to_wall.jpgPachiWall05_FrameBoardsCut.jpgPachiWall06_Drilled.jpgPachiWall07_PocketHoles.jpgPachiWall08_Frames.jpg
Reply With Quote
