Hi all,

I have been getting a tingle from the chrome on the front of my fever queen, I checked the power cord and it was 2 prong, and inside on the power supply I could see the ring terminal with a cut green ground wire.

My question is this, I have a new 3 prong cord but on the power supply the original cord connects with a plastic connector to the power supply, do I just clip that cord leaving a few inches of leads to connect the new cord? if so how do I attach the new cord? (wire nuts? crimp on butt connectors?)

Basically I am just wondering the safest and best way to couple the wires together inside the machine.

Hope this message is not too confussing of what I am trying to accomplish.

Thanks in advance!

PS I did do a search but could not find the way to connect the 2 wires.