Cranky Condor - Reel Light replacement

[Hinckley_Buzzard]

Is there instructions posted anywhere to change a light bulb behind a reel?

Also, where is a good source for bulbs?

Thanks!

[DaStooge]

Try these 2 threads http://www.pachitalk.com/forums/show...01&postcount=1

and ... http://www.pachitalk.com/forums/show...ighlight=bulbs

hope this helps

[Hinckley_Buzzard]

The Cranky Condor I have is most likely 8 to 10 years old and does not use LED's. The bulbs look like a tiny clear light bulb about 3/4 of an inch long. For lights on the door that I can access directly, they seem easy to replace.

For bulb that's out, I can't see how to access it. I think there are three bulbs behind each reel and one of them on my center reel is out. I must have to pull the reel out.

Any other Cranky Condor owners out there?

[alstonj1]

The Cranky Condor I have is most likely 8 to 10 years old and does not use LED's. The bulbs look like a tiny clear light bulb about 3/4 of an inch long. For lights on the door that I can access directly, they seem easy to replace.

For bulb that's out, I can't see how to access it. I think there are three bulbs behind each reel and one of them on my center reel is out. I must have to pull the reel out.

Any other Cranky Condor owners out there?

most likely you do have to disconnect the plugs going to the reel in question then unmount the reel by taking out the screws holding it in then pull it out . you should have access to the bulb bases like the ones on the door their usually 1/4 turn bases that pull out then pull the bulb out of the base and replace it but while your at it I'd replace all three and while your at that you might want to do the other two reels one at a time .just make sure you put the reel in right it should fit easily no need to force it .if you do your doing something wrong . turn the reel after replacing it and the hardware holding it to see it moves freely then go on to the next . good luck

[melloed]

I have a cranky condor the bulb is a 24volt 1/4 wedge remove the screw that holds the bulb assy it will slide out from the wheel twist the black bulb holder pull out the bulb and replace.also if you have a manual for that machine I need a copy thanks

dave