My King Camel

[Bobby]

My King Camel should be here any minute. I can't hardly wait.

[vgc]

One of the best, if not The Best, Cheaper Non Video Machines out there. Don Don King is up there as well, and Giga Fever just below those 2 in my opinion. Mike : )

[7mileslots]

You didn't by chance buy this one from Milt did you?

[Bobby]

I got it from 5Star. I have a question: On the reel stop buttons the left button stops the right reel and the right button stops the left reel. Is this the way it supposed to work?

Also this thing was packed very good. The box was torn all to He** but the machine was in great shape. Not a scratch on it. Very clean

[7mileslots]

Open your door. Locate the wires from the back of the buttoms. The plug for the 1st button is plugged into the slot for the 3rd reel. Swap the plugs and you should be all set

[Bobby]

Here is a picture of the back of the reel stop buttons but I only see one wire going to it.
http://www.texasbeachbum.com/DCP_2962.JPG

[luckydog]

I think he is talking about the plugs right by each reel, they aren't in the right order.

[slotter]

Could that connector be plugged in upside down going into the board?

[luckydog]

slotter,

looking at the colored wires you may be right,

[DiskDevil]

I just checked mine...and by the picture...The plug going into the stop button board is in upside down. the side with the red wire is on the left on both boards.

[slotter]

Yup... that's what seemed logical. You should be in business soon!

[vgc]

What was the Inspectors Number ?, should have been around key in bag. I will smack him in the head next time I am in there. Mike : )

[Lddrizzt]

Just looked at mine also, I agree, the bottom plug going into the board is flipped

[Bobby]

Sorry I went out fishing yesterday afternoon and didn't get a chance to look at it I will today. I just need to turn that plug over then right?

I did catch some fish.

[Bobby]

I forgot it was inspector #9

[Bobby]

Ok is this the connection I am supposed to turn over?
http://www.texasbeachbum.com/stopbutton.jpg

[luckydog]

yes, one end is reversed, the red wires should be on the same side.

[Bobby]

I just talked to 5Star tech and he told me to take the circuit board off and turn it over. He also didn't know about this forum I guess he wanted the www address for it. I gave it to him.

[ol-pachiman]

You need to flip the board, the plug needs on the board needs to be on top towards the key side of the machine. they are two screws holding the board in place.

[ol-pachiman]

Heres a Picture of my KC board