Questions on the options with a new model Pachinko

[Spear]

Hey, it's been ages since I've been here...

So, I have a Danmachi pachinko I bought via the FB group last year. Other than a snafu with the transformer (seriously, buy the one they offer) I've been enjoying the machine.

Some questions....

1) does anyone know if there's any way to change the text to english (I'm assuming the audio would be a no-go). Admin menus or total firmware replacement?

2) is there any way to get the volume levels down? I've got the settings as low as they go, and it's still pretty loud.

[takethecastle57]

and biscuits

You see that Big Crystal Ball in the Front of your machine .


When not playing , move the ball to your left or rotate it to your left (counterclockwise) . That should reduce the Volume of your machine .

I have a 2020 Pachinko machine and when I move that medallion to the left it does quite the machine to less Ear Bleeding Levels .

[lotsoballs]

I have this exact model; mine is not “too loud” however; there’s normally a master volume switch or knob on the back of the cell that controls the master volume (not the volume buttons on the front) I’ll take a look at mine later.

I’ll bet if you poke around back there you’ll find it!

[lotsoballs]

I just checked mine; it does indeed have an easy to locate master volume knob (the yellow knob) on the back of the cell. Just need to open up the dust cover on the rear to access it.




Sent from my iPhone using Tapatalk

[Spear]

Thank you all who offered helpful suggestions, but let me put a bit of info out there...

1) "too loud" is a subjective thing. Telling me your machine isn't too loud isn't helpful. I might agree your machine isn't too loud, I might not. But these machines are design to compete for attention in a packinko parlor, so they get pretty loud. For me, and where my machine is, it's too loud.


2) I've done the simple things. IE volume knob, volume controls on the front. I'm at the point of non-simple fixes here.

Also looking more info for the on-screen text conversions... I would belive it's possible, but the question is, has anyone done anything like that? I have seen the manufactures for pachi slot machines starting to put in dual language software.

[rockston]

Hi, and welcome back! Here is what I use for volume attenuation and it usually works smooth all the way to near zero output.
The wiring diagram is on the box and you'll need a soldering gun, some wire and heatshrink tubing for a neat install.
If you have a three speaker system you will need an additional mono lpad. Some people use less expensive
cheap 500k pots in line however this pot is actually designed to control the amps output to the speaker without damage.

https://www.ebay.com/itm/16612062119...mis&media=COPY