Pachislo Yasama King Pulsar- Reel Lights Dull Red.

[CollinP]

Hello,
I've just bought my first machine and it's a Pachislo Yamasa King Pulsar. The machine seems to work as it should but the reel illumination lights seem cast a dull red glow once the machine is turned on. I can see the images on the reel well enough but, not being familiar with the machine, I'm not sure if that colouring is correct. I was expecting it to be brighter. The reel material is clean and white and in decent condition. I was wondering if I may need to replace some bulbs. Any feedback would be appreciated.
Thanks. CollinP

[grizzlypower2001]

Add some pics and we can see what your talking about better. I had a few of Yamasas.

Sent from my SM-G975U using Tapatalk

[CollinP]

Thanks for the reply. I hope these pics are good enough. The red cast over the reels is with the machine switched on and the other is the machine switched off.

[grizzlypower2001]

Ya that does look much more red then my old machines. I believe they are LEDs behind the reels, in a white pod if you want to call it. Since they are all the same shade, I would look where they connect to the mother board. I looked at an old video on mine and it does kick the red glow, but doesn't seem as bad.

Sent from my SM-G975U using Tapatalk

[CollinP]

OK. Thanks so much for your help and time. I'll take out the reels and see if I can see anything obvious. Would you happen to know the bulb specs? Cheers

[compirate]

Could be RGB LEDs, other colors aren't lighting. Check connections/continuity on wires.

[SuspicousSodaFountain]

OK. Thanks so much for your help and time. I'll take out the reels and see if I can see anything obvious. Would you happen to know the bulb specs? Cheers

Theyre most likely surface mount leds or thruhole leds. its of higher chance that your in some form of minigame mode. i know mine does that during its special mode (diff machine but you get the point)