Cabinet for pachislo
I just finished my first pachislo cabinet. It's nothing fancy, but I wanted something that would look nice sitting next to my pachinko cabinets and raise the machines to the same height.
I messed up badly with the vertical cuts and ended up with two diagonal boards that were 1/8th of an inch too short, so I had to route, cut and sand the board above the machine to make it fit. On the inside it looks terrible but I am still happy with the result. I forgot to take in progress pictures so I only have the results here:
PS1.jpg
Boards cut (all 3/4" plywood):
1x 20.25"x32", then cut diagonally at the 8.5"/11.75" point on the short edge to the opposite point at the 11.75"/8.5" point on the opposite side) - Sides
2x 20.25"x 9.5" - Top and lid
1x 20.25"x16" - Bottom, rounded corners on the front
2x 9.5"x2.75" - Sides, top box
1x 18.75"x2.75" - Front of top box for data counter. Needs a center hole for the wiring.
Reply With Quote
