Sankyo Part Removal Question

[sparky kilowatt]

I'm in the process of trying to remove the ball feeder (I think that's what it's called) from my Sankyo that I'm trying to restore in order to clean and polish the plastic pieces, but I can't seem to figure out how to remove it.
First picture red arrows in the middle show where I removed 2 screws, the circles with question marks are the 2 things I think may be holding it in, but I'm not sure and cant' figure out how to remove them or if they even need to be removed.
Probably totally missing the obvious, but I'm stumped. Can anybody offer some support please?

[Bowl987]

I'm not knowledgeable enough yet to give you an exact answer, but I've learned a lot from this youtube channel.
https://youtu.be/nI5-nkC0fOY

[sparky kilowatt]

Thanks, I'm a subscriber to Dan Welch's channel as well. That video is somewhat helpful, but I'm not clear on if he removed or did anything on those two posts prior to pulling on it, I don't want to break it.

[sparky kilowatt]

Well, I got it out, thanks to Bowl987 and Dan Welch's YT channel, I wiggled, pulled and very slowly and carefully removed it. Now to pull all the little "e-clips" and clean that sucker up!

[Moparformances]

yep flip the locking lever and pull it straight off.. its pressure fit

[sparky kilowatt]

yep flip the locking lever and pull it straight off.. its pressure fit

Thanks, I was a little hesitant to "muscle it", a little bit different than my Nishijin, but now that I've done it once, I'm good to go!