Results 1 to 2 of 2

Thread: Adjustment hammer & ball gauge

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Blind Shooter Mr.Lazo's Avatar
    Join Date
    Apr 2019
    Location
    FL
    Posts
    68
    Thanks
    37
    Thanks Received
    116

    Default Adjustment hammer & ball gauge

    Found these at the hardware store yesterday:
    nail tools.jpg
    The hammer is a Hawk brand 8 1/2" hammer with a 1/2" diameter brass head.
    The springs are tubing benders; I took the smallest one, evened out the flared end with my dremel, cut a few lines in the bottom of a ball (also with the dremel), and JB Welded them together.

    The spring is stiff enough that it supports the weight of the ball even when held horizontally.

    Adjusting nails with the hammer is strangely satisfying, compared with the duct-tape-wrapped angled needle-nose pliers I was using previously.

  2. The following 7 users say "Thanks" to Mr.Lazo


Similar Threads

  1. ball launcher knob, spring adjustment?
    By rlazars in forum Modern Pachinko
    Replies: 4
    Last Post: 02-11-2015, 06:23 PM
  2. Sankyo ball gauge set
    By TomscottVikky in forum Yahoo Japan - Auction Area
    Replies: 10
    Last Post: 03-20-2013, 07:50 AM
  3. Ebay Auction : Sankyo Pachinko Hammer and Ball Gauge
    By hanabi in forum eBay - General Auction listings
    Replies: 35
    Last Post: 10-16-2012, 03:06 PM
  4. Pachinko Doctor - Gauge hammer and replacement Nail set! KUGI-SHi SETTO
    By candyflip in forum Yahoo Japan - Auction Area
    Replies: 0
    Last Post: 02-24-2011, 07:54 PM
  5. E.T Ball Shooter Adjustment
    By portercbl in forum Pachinko Modifications
    Replies: 2
    Last Post: 09-14-2006, 02:23 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •