Results 1 to 6 of 6

Thread: Sankyo Victory frame cell swap compatibility questions

  1. #1
    Pachi Puro lotsoballs's Avatar
    Join Date
    Nov 2014
    Location
    Charlotte NC
    Posts
    2,129
    Thanks
    1,494
    Thanks Received
    4,050

    Default Sankyo Victory frame cell swap compatibility questions

    I finally got around to attempt a cell swap on my Road Construction hanemono (Victory frame), since I don’t play this machine much due to annoying jackhammer “music”; but I’ve run into a dead end when attempting to swap in Aqua Paradise. I got both from Compirate (thanks!) thinking it would be an easy cell swap; however the connectors are different sizes on the board attached to the frame itself. 😕



    Not sure if this frame has different versions? Or is there a different board that attaches to the frame (specific to this cell?? 😕

    Here’s a pic of back of the aqua paradise cell (notice the 3 large white connector wires; and 2 large female connectors):

    And here’s the back of the frame with Road Construction installed, I disconnected the wires to show the connectors are different sizes and there’s a blue connector... all connectors are white on Aqua paradise, so I’m stumped on how to swap it.



    Compirate, I know it’s been 2 years since I picked these beauties up; any ideas? (Do you still have Aqua paradise’s original frame?🤞If so is the lower board attached to the frame itself different?) I had a similar issue swapping Apollo 1 into my Maturi Penguin’s frame, hopefully I can figure this one out too! Aqua paradise still sells for quite a bit on yahoo japan, so it’s gotta be good! (For a 10+ year old machine &#128512

    Any help would be appreciated!


    Sent from my iPhone using Tapatalk

  2. #2
    Master Inventor daverob's Avatar
    Join Date
    Nov 2005
    Location
    Brighton, UK
    Posts
    1,365
    Thanks
    1,961
    Thanks Received
    7,101

    Default Re: Sankyo Victory frame cell swap compatibility questions

    Your Aqua Paradise Cell picture is showing the cell with the AV control boards on it, but no main CPU board for the cell, so your free wires are supposed to go to the Aqua Paradise CPU board.

    On your picture of the New Road construction you can see the blue labels on the CPU board (that you have removed the connectors from) that match the blue labels on the AV control board on the back of the cell (as both are from New Road Construction). OK, they don't 100% match, as the Japanese writing on the AV board says 'New Road Construction Series' and the CPU says 'CR New Road Construction SP', but they're definitely part of a pair.

    So it looks like you need to find the CPU board that goes with the Aqua Paradise Cell, and swap that over along with the rest of the Cell.

  3. The following 6 users say "Thanks" to daverob


  4. #3
    Pachi Puro lotsoballs's Avatar
    Join Date
    Nov 2014
    Location
    Charlotte NC
    Posts
    2,129
    Thanks
    1,494
    Thanks Received
    4,050

    Default

    Thanks Daverob...hopefully the missing board can be located as I’m sure it’s next to impossible to find a replacement! 😬


    Sent from my iPhone using Tapatalk

  5. #4
    I was thrown out of Top Gear Drunkenclam's Avatar
    Join Date
    May 2010
    Location
    Guildford, Surrey
    Posts
    28,495
    Thanks
    13,435
    Thanks Received
    18,805

    Default Re: Sankyo Victory frame cell swap compatibility questions

    I'm sure Compirate didn't stitch you up, it will be somewhere.
    Ian #UKPachinko

  6. #5
    Gibisans - Japan West compirate's Avatar
    Join Date
    Feb 2005
    Location
    Down in da Holler, WV
    Posts
    9,106
    Thanks
    8,726
    Thanks Received
    18,435

    Default Re: Sankyo Victory frame cell swap compatibility questions

    I go dig for it tomorrow, sorry 'bout that!

    人生は恐れなければ、とても素晴らしいものなんだよ。
    人生に必要なもの。それは勇気と想像力、そして少しのお金だ。

  7. The following 2 users say "Thanks" to compirate


  8. #6
    Pachi Puro lotsoballs's Avatar
    Join Date
    Nov 2014
    Location
    Charlotte NC
    Posts
    2,129
    Thanks
    1,494
    Thanks Received
    4,050

    Default

    Thank you Compirate! I will pay for shipping of course. No problem at all! Apparently these frames aren’t quite as cell swap friendly as a Lumina frame (or others). Many thanks for the numerous treasures you’ve given me or sold at rock bottom prices! (Star Wars, Cutie Honey, Apollo 1, Animal land, Vicky Chance, 007, Loony toons, and many more of my personal favorites! 👍&#128512


    Sent from my iPhone using Tapatalk

  9. The following user says "Thanks" to lotsoballs


Similar Threads

  1. CELL SWAP - Sanyo inside Monoka Frame!
    By jodini in forum Vintage Pachinko
    Replies: 8
    Last Post: 04-18-2013, 03:41 PM
  2. sankyo victory frame parts
    By TomscottVikky in forum Members Trade area
    Replies: 0
    Last Post: 03-04-2013, 02:21 PM
  3. Sankyo Super Stadium Cell Swap
    By portercbl in forum Pachinko Technical Support Tickets
    Replies: 3
    Last Post: 11-15-2010, 11:26 PM
  4. Victory Frame Cell Wanted
    By portercbl in forum Members Trade area
    Replies: 0
    Last Post: 04-25-2010, 01:30 AM
  5. Cell Swap Video - Kyoraku Big Bang Frame
    By rubberratt in forum Modern Pachinko
    Replies: 40
    Last Post: 04-17-2009, 03:09 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •