A couple thoughts for you to consider in your possible future use if you have multiple machines using the same cabinet or clones of the first cabinet. Not that I've built any yet myself but I understand that some machines run slightly wider than others. Something to consider if building multiple cabinets over time. You could stay with one plan on the wider size and shim a thinner model if needed. Not sure how that would work out or look.
If you ever put a modern machine in the cabinet then perhaps extend the board under the bottom of the machine out some to serve as a tray holder. Once a modern starts paying out in a fever round you would be emptying the lower reward bin and the loser balls can still be accessed below that. This is a picture from another member and I'd like to try this design someday.
74014d1301434913-new-cabinet-source-town-dscf3399.jpg74013d1398525173-new-cabinet-source-town-pachinko-thunderbird-004.jpg
Re: Looking for input on cabinet design
Originally Posted by Peteybob
A couple thoughts for you to consider in your possible future use if you have multiple machines using the same cabinet or clones of the first cabinet. Not that I've built any yet myself but I understand that some machines run slightly wider than others. Something to consider if building multiple cabinets over time. You could stay with one plan on the wider size and shim a thinner model if needed. Not sure how that would work out or look.
Reply With Quote
