I think the next step while waiting on my new opti sensors to arrive is to correct my tilt problem.

Upon powering up the machine is in tilt mode and a relay on my circuit board is clicking.

Relay Labeled.jpgTilt Leaf Switch & Solenoid Labeled.jpgTilt Pendulum Removed.jpg

I really want to bypass the tilt feature completely to eliminate it as a potential problem.

As near as I can tell there are two ways tilt is activated. One is with the pendulum, which I have removed completely. The second is a leaf switch that open if the machine in opened up. I put a clip on this switch to keep it from opening.

My machine is still in tilt mode, the relay is clicking which is attempting to activate the tilt solenoid.

Any suggestions how to completely bypass the tilt system?