Tarot Master help with CJ error

[dvw]

I have a Tarot Master slot machine. When you turn it on it makes musical noises and had a CE error. I took the coin mechanism out and cleaned it. It did have rust on it. Error CE is gone, now I have a CJ error. Anyone know where I can find a coin mechanism for mine. I have tried reset and it doesn't work. If I am doing it right. I have noticed another key slot on inside upper right hand corner covered with a black cover. I have only 2 keys for the machine. Door key and key for reset on power supply. thank you

[Moparformances]

im no Pachislo pro but i do have this copied from somewhere (hear i guess)

ErrorCodes

E-0/ (CE/CJ) = The token slot is jammed.
-Remedy: Push the button at the token slot.
E-1/ (HE/ HJ) = The hopper is jammed.
-Remedy: Turn off the machine, remove the hopper and take out all the tokens. mannually turn wheel witha few tokens and see if it ejects tokens properly .check sensor is clean .
E-2/ (HE/ HJ) = Hopper malfunction.
-Remedy: Check the hopper.
E-3/ (HE/ HJ) = The hopper is empty.
-Remedy: Refill the hopper.
E-4/ (RR) = RAM error.
-Remedy: Push the reset button.
E-5 = Reel error.
-Remedy: Restart the machine and push the reset button.
E-6/ (CO) = Prize error.
-Remedy: Push the reset button.
E-7 = Hopper Overload.
-Remedy: Check the hopper.
E-8 = Hopper disconnected.
-Remedy: Check the hopper cable/connector.
CE/CJ/C2 = The token slot is jammed.
-Remedy: Clean token mech and reset machine,
OF = You have hit a Big Bonus and the machine needs to be reset.
-Remedy: Push the reset button and/or do the reset procedure.
HO = Hopper out, same as HE. The hopper is disconnected.
-Remedy: Make sure all cables are connected and you hopper is connected.

and of course

Welcome to Pachitalk

[Moparformances]

these are the directions i have for a full reset..

In order to do a full reset or change odds, machine must be in idle mode with no tokens or credits being played.

Locate internal toggle switch (red tipped or silver with on/off tabs) or insert key into internal key switch (if your machine came with 2 keys).

Machine must be turned OFF. Turn key clockwise or flip reset toggle switch to the "ON" or "ODDS" position. Turn main power switch ON to access programming mode.

A number from 1 to 6 will be displayed on the CREDIT meter on the front door or on a display inside the door.

Locate the reset button. This will be located on your power supply. On SAMMY brand models, the button is on the inside of the door only.

Depress the button and notice movement of number being displayed on the credit meter. Once the desired level is displayed (1 to 6) pull "spin reels" handle (black or red knob on front door) down, like you are going to spin the reels, to lock odds level into machine memory.

Turn key switch back or flip toggle to "OFF" or "PLAY" position. Machine should immediately initialize. You will know the machine initialized if the "Insert Medal" light starts flashing. If not, make sure you remembered to press down the "SPIN REELS" lever. If it still doesn't initialize, turn power to the OFF position, wait 15 seconds and turn power switch back to ON position.

[dvw]

No coin is jammed. I believe the coin mechanism is bad. Now looking for ideas on how to bypass the coin mechanism since I cannot find another one to replace it