WTB Yamasa coin mech
Hello everyone,
I am new here to Pachitalk but I am happy to be a part of the family here. I was hoping someone would be able to help me. I am in need of a Yamasa coin mech. I just bought a Pulsar Pachislo and it was showing the code E0. after a lot of research and trial and error I found that if I unplug the coin mech and do a full reset the alarms will stop sounding and the error was cleared. Once I plug back in the coin mech boom light and sounds are going off and the E0 code is back, I tried to reset it again but the E0 code keeps on coming back so I have come to the conclusion that the sensor is bad and needs to be replaced. I am not sure if anyone just has the sensor but I will tech the coin mech also if you have it just incase something on that is bad also. I have included a picture of the coin mech that I need with the correct wiring harness. Thank you so much in advance to everyone here at Pachitalk and I fingers crossed that I can get this machine up and running.
Reply With Quote
