pulling hair out

[dattia]

West Chester....Southeastern PA

[Lddrizzt]

Ok try this:
1) make sure you got a bunch of coins in the hopper.(hold back 12 coins)
2) shut off machine
3) turn reset key/switch to on
4) turn on machine with reset still on
5) change odds setting to a different number (1-6)
6) depress joystick for 10 seconds
7) turn reset key/switch to off
8) close door
9) insert all 12 coins that you held back
10) depress joystick and hopefully your reels will spin

[Utopia1dc]

dattia-

You are very close to at-slots (10 minutes), give him a pm. He should be able to help you out.

[dattia]

Yes, they register in the window marked credit. The paylines light up as they should. The "MAX BET" button has never lit up (if it is supposed to) and the other bet button (located beside the cancel button) doesn't seem to to anything when depressed. The number stays the same in the credit window.

[dattia]

OK forgive my ignorance...what is a pm?

[RKnarr01]

do you have a wire running from the joystick to a circuit board?

[luckydog]

are you pressing down on the joystick after putting coins in?????

[RKnarr01]

PM private message

[luckydog]

http://www.pachitalk.com/forums/member.php?u=1280

[dattia]

Lddrizzt - Thank you, but no luck

[dattia]

Luckydog - after putting the coins in, I push the bet button but nothing happens, the coins are still registered in the credit window. Then I try the joystick, nothing again.

[RKnarr01]

dattia make sure theres a wire running from the joystick to a circuit board.

[Tulsa]

Does the joystick light up?

[dattia]

Yes it is a lovely bright red...all lit up.

[dattia]

When I moved the joystick, I located a set of four wires slightly moving behind the door. I am assuming they belong to the joystick. They are attached to the circuit board by a small blue connector (probably not correct terminology). Dawn

[Utopia1dc]

PM is a private message (like email within the forum). Just send one to at-slots, he will help you out. You are a short drive from his warehouse.

[dattia]

Thanks Utopia1dc - I just sent the message. Looks like you are close by too.

[RKnarr01]

dattia at-slots is on the board now but his PM's are not working so i will tell him to come check out this thread

[dattia]

Thank you all for your help. Dawn

[Utopia1dc]

Thanks Utopia1dc - I just sent the message. Looks like you are close by too.

Yes, I am in Gilbertsville (Boyertown/Pottstown).