Vintage New Gin Full Cyclic
Another project machine...
Thought I'd post as it goes along because this will take a while and get put on the back burner a few times before it is done.
It started as a regular clean up; discovered this machine had a broken rocker and it's not common.
Didn't think I'd find a replacement part soon.
Broken New Gin Rocker.jpg
Next came some general clean up.
Nails half done.jpg
I'm going to use one of my counters / games and have a few extra outputs on the Arduino.
Added this micro servo to open two tulips on demand. Used braided fishing line for the "wire".
This is intentionally slack and allows the original tulip lever to act as it always did.
Kind of a "Quarter" power flash?
Servo.jpg Servo Line TOP.jpg Servo Line BOTTOM.jpg
Reply With Quote
