IGT Terminator - Partial Error Code

[akbulll]

Have a partial code on IGT terminator. I have reset the game many times but no change.
Any suggestions as what the problem might be and how to fix?
Thanks.

[Wayne-Ooo]

A "hard reset" should clear any error code. I know you said you have done several resets. Just to make sure you are doing the reset correct, here are the steps. Each step must be done in order and exactly as stated or the machine does not reset.

1. With the power to the machine OFF, turn the reset to the right. (You may have a toggle switch instead of a key. If so, flip the toggle switch.)

2. Turn the power to the machine ON. (The machine stays ON from this point. DO NOT TURN IT OFF.)

3. Hold down on the spin lever. (Release after 5 seconds).

4. Turn the reset key to the left. (Or if you have a toggle switch, flip the switch back.)
(While turning the reset key to the left, you should hear a "click sound" from the coin mechanism. If not, the machine did not reset.)

If all went OK, the machine should be reset at this time and all error codes should be gone. If you have done the reset correctly and still having a problem, I'd start resetting connections. Start unplugging connections and plugging them back in. Do all the connections in the machine, it's a lot of connections but DO IT. It only takes one loose connection to "screw up" the operation of the machine.

[luckydog]

also check that the hopper wheel will turn easy by hand and that your tokens are clean.