Re: I have a machine that I have no idea of it's name
On the front door circuit panel Is the Bet button wiring the orange 5 wire connector?
Most likely a 5 wire connector. Red,Orange,Blue,Black and Yellow wires.
You could bypass the button buy going directly to the wiring. The Black and Yellow wires are what makes a Max Bet. So you could splice into those two wires and add some jumper wires, touching them together would be the same as pushing the Max Bet button.
What if...the HOKEY POKEY, is what it's all about?
Re: I have a machine that I have no idea of it's name
Wayne,
Thanks for the wireing tip... as to the color code
after futher inspection... I see the #9 & #11 leds are triggered by the
coin dropping thru the mech...
I have a constant led 7 light on.. which could possibily mean that the
bet button is stuck... (I am assuming that #7 is the bet button led) does that sound reasonable...
how do you remove the bid button?
Re: I have a machine that I have no idea of it's name
Led's #1,2 & 4 flash when the reels are spinning.
Led #3 is the right Stop button.
Led #5 is the left Stop button.
Led #6 is the center Stop button.
Led #7 is always ON.
Led #8 is the Spin lever.
Led #9 & 11 are the coin sensors.
Led #10 is the Max Bet button.
Re: I have a machine that I have no idea of it's name
Do you think that the circuit board that has the reset button on on the inside of the door is where the problem might lie...
I believe everything up to that point is operating the way it should... I however don't have any idea where to go other than to replace that circuit board anybody have any thought on this idea...
Roger
Posting Permissions
