Need Help Reels not spinning

[jjoravec]

I have a skill stop slot and the reels will not spin. I checked all the connections and performed a reset (several times), but nothing. The machine will accept tokens and register then, but no matter what I do the reels will not spin. For kicks I took out the stop board and it does the exact same behavior; accepts tokens, sound lights everything, but no reel spin.

So does this mean the stop board is bad and if so where can I get one? I tried stealth and they don't have any. It's the newer style stop board. I can post a picture later.

Thanks

Joe

[Drunkenclam]

Can you check the signal is coming from the start lever. You should be able to check to see if all buttons are functioning by the LEDs that light up on the motherboard. Double check to make sure none of the buttons are stuck. Check each button to make sure a led comes on.

[jjoravec]

I checked and see a LED light up for each of the stop buttons, the Bet buttons and the lever, so they appear to be functioning. It just won't spin when I pull the lever.

I can post some pictures later when I get home.

-Joe

[new in town]

Hi and Welcome to PachiTalk.

Can you tell us the Name of your Pachi Please.

Does your Stop Board look like any of these, :

PIC 1.jpg Oldfrnt2.jpg HS2012F.jpg PIC 2.jpg


Let us know which one. We are Here To Help you in ANY way we Can.

[jjoravec]

It looks like the last one.

PIC 2.jpg


The one thing I noticed on the stop board is that when the door is open, LED 7 is blinking red and if I press in the door switch button it will stop blinking and turn to solid red light. It never goes out totally, is this normal?

[jjoravec]

I found the problem. It was a bad connector to the stop buttons, replaced the connector and all is well.

Thanks for the help it guided me in the right direction.

[new in town]

The Board you have installed is not a Stop Board. It is called a "Parlor interface Board". The new Pachi's have the Stop Board now mixed in with the Main Motherboard. If you would like the break Down on the LED's on the Parlor Interface Board Please let me know.