Looney Tunes BIA cel

[ryantiger99]

Hi Pachitalk gang,
Well received looney tunes BIA cell for lumina frame ( desk top or demo model ) removed speakers x 2 from the back with x 2 volume pots and power supply board also hot glue removal from the x 2 40 pin connectors ( top board) ...will post pictures of this whole process I have some missing cables list as follows

40 pin White connector cable X 1 or 2 preferred ...marked CN3 ( top board )

( bottom right board)

2 pin yellow connector cable x 1...marked CN8
7 pin red connector cable x 1...marked CN4
9 pin blue connector cable x 1...marked CN5


Has any one got any advise on where I can purchase these missing cables ??

I am trying to make my own cables in the interim

I have ordered from RS some molex connectors with pins ,cable 20 awg and pin connector crimped tool which I think may be the same so I can make my own ?? Problem is I can't find a 40 pin molex connector ??

[ryantiger99]

Hi pachitalk gang,
After hours of research I have discovered exactly what connectors are required for my lumina cell sankyo missing cable these can be purchased from rs components online for those of you with a similar issue ...enjoy !

Perhaps I can get a job in Japan for sankyo

MicroClasp

[Drunkenclam]

Sorry. I've been away this weekend. The yellow plug is from the start pocket sensor. Not sure if you take it apart more, it might be hiding inside. The white plug should have a lead from the transformer, the pink one. The brown plug goes to a board, then splits up to lots of different coloured plugs that go to the rest of the ball sensors, jackpot door and tulip solenoids. Hope that's of some help. A bit brief but I'm trying to cook dinner

[Drunkenclam]

Opps, ran out of edit time, the blue connector, turns into the pink connector on the frame for payouts, if making your own, I would try to get the same colour plugs, At least you have done test leads to play with