Beast Sapp Reel Lights

[alexilla]

LEDs typical life expectancy is approx. 50,000 hours of use, so that means they would have to be on CONSTANTLY for 5 and a half years before they come close to burning out. So if they are burning out expect there to be a problem with your machine's electronics or power supply.

[vgc]

LEDs typical life expectancy is approx. 50,000 hours of use, so that means they would have to be on CONSTANTLY for 5 and a half years before they come close to burning out. So if they are burning out expect there to be a problem with your machine's electronics or power supply.

-

Not with these buggers. I have had a few of these machines with lights partially out. 1 had all 3 with imperfections, DGI sent me replacements twice and both replacements were bad as well. Mike : )

[rogerg]

This is probably a dumb question but what colour should the LED's be showing?

When I look into the side of the reels on my Hanabi some are bright blue, some are bright orange/green and some are very dim just showing red/green/blue dots.

The other strange thing is that the led's show the same colour characteristics in pairs. So is the problem just the LED's or the circuitry in the machine?

As previously asked why do you need RGB LEDs when the only desired colour is white?

I have sourced a supply of suitable of 6 lead LED's in the UK but they are about $7 each and with a total of 18 in the machine this could be an expensive repair.

Any ideas Guys?