Re: pinball/pachi room
did a little revision on the arrangeball wall. i ended up mounting the machines to brackets so they'd be supported from the bottom as they are designed to be. i used 3" long masonry/plaster screws which look like augers basically. each bracket gets 2 and goes thru the plaster, wood lath, and then the cinder block behind that. the top bracket just uses one of the screws and then a machine screw extends down into the top of the machine and is secured from the inside with a wing nut to allow for easy removal if i need to take the machine down. also, a safety wire is attached to the top of each one and fastened to a 4X4 beam that runs above all the machines. the robots machine on the far right didn't get done since i ran out of screws but it'll get done in the next day or so and made to be more level with the others.
Reply With Quote
