stripped the first batch of machines tons of parts up on ebay

[discgolfer72]

well striped down the first batch of machines today and got a ton of parts up on ebay
http://www.ebay.com/sch/diehardarcad...id=p4340.l2562

also before i list them on fee pay anyone need any rust free sankyo metal frames back plastics or shooter motors

[mxfaiman]

What is the sizes on those frames? (out side and in side) And what is the size of the ball tray panel insert? I might take a few if the will work good in my vintages.

[discgolfer72]

sorry for the late reply been out with the gf
do you need the measurments of the opening in the machine itself or do you want the actual measure of the frames

[mxfaiman]

sorry for the late reply been out with the gf
do you need the measurments of the opening in the machine itself or do you want the actual measure of the frames

The picture below kinda shows what I want. I mainly need the size for the hole it fits in. But I'd also like the size for the ball panel and the size for the plexi to slide into it.

[discgolfer72]

Not at home now at the gf's but I know it uses the standard 16x16 glass had 10 cut the other day for all my machines (the only ones that the glass didn't fit were the murhon and toyttech that used 16x 15.5I'll be home tomorrow afternoon and I'll get the other measurements for you

[discgolfer72]

ok finaly

had a chance

17.5 x 21.5 is the opening in the cab itself
franes are 18 3/8x 22 5/8 outside measure
21 3/8 x 16.5 inner backside lip


ball tray is 17 1/8 x right betwene 4 1/4 n 4 3/8 thats without mesauring the lip that goes behind the top door with lip its a total of 4 6/8

[mxfaiman]

Well I went and checked last night and my plans won't work. So I'm not going to be a buyer on the frames even though they look really nice.

Thanks for all the help though.