New to Pachislo and this forum, just acquired a machine

[jasew503]

Hello everyone, Im new to this forums and these machines in general. I just got my hands on a NET Jungle Beat 3-Reel Slot machine that was torn apart when i got it. I have put it pack together and when I plugit into AC Power it appears that everything works. All lights work, and the LED Display shows text and graphics. One problem: Im missing the Coin Acceptor part which I assume plugs into a 6 pin connector on the board inside the door labled "CN10" since this is the only exposed connector nearby. I would like to get it into play mode or spin mode to see if everything else works. Is there any way to touch a couple of the leads on this connector or break a circuit somewhere to add a credit? Also, the hopper continues to spin, not sure if it does that because it needs some tokens or what. Thanks a lot

[njmatt]

Some pictures would help immensely. The hopper is probably spinning because the hopper switch (which is used to empty the hopper) is switched. It could possibly be located on the hopper itself or on the power supply.

[jasew503]

Thanks for the reply, I have some pics, however i dont know how to upload them. The hopper stays spinning regardless if the reverse switch is in reverse or normal. If I unplug it from the power supply unit labeled "K1" (red faceplate) while the machine is running it obviously will stop, the machine will indicate "trouble" on the LED overhead display and play twilight zone music if I turn the power off and back on again, until I push the reset button. Ive tried shorting a few combinations of leads on the "CN10" connector to no avail. Ive since removed the reel unit and proceeded to convert it to a video machine with a 15" LCD touch and an IBM ultraslim with a Konami Gaming rom for now. And no, I havent cut or permanantly modded anything yet! Just removed the glass front and reel unit, so far.

[jasew503]

Im using a Lenovo (IBM) SurePOS system seems to work with this config so far, if anyone wants the parts from this machine let me know. (NET JUNGLE BEAT)

[takethecastle57]

Very simple to post pictures here !!


on the bottom of the reply box there is a "Go Advance " tab , click on that then scoll down the new page and upload your pictures

[jasew503]

does this work?

[takethecastle57]

Thank you for the pictures . Have you tried to clean the hopper mechamism with Q-Tips and Rubbing Alcohol the optical sensor could be dirty and would cause the hopper motor to keep spinning .

just my 2 tolkens worth

[jasew503]

Not sure if anyone understood me, at this point unless someone has an answer as to "how" to add a credit this machine it is going to be gutted out, and all parts are free, ill respond with a pic of the reel unit i took out just to re-affirm that im gutting this out and all parts are free.

[jasew503]

ive started taking it apart, heres additional pics of the reel unit if anyone wants it.. remember free, as long as someone can use it.

[compirate]

Let us know how the gaming cabinet come out, sounds interesting!

[jasew503]

thanks for your positive support, Im actually doing all this while working, actually mounted the lcd but ran into some other issues, I have pics, will post as i can, youll see the issues as well..

[N8IWS]

I could use the reel assembly, power box and hopper. I have a NET machine that has issues too, but mostly I can't locate a reel set.

Send me a PM.