Cabinet for Hyperpassion! Newbie!!

[hondachip]

I am new to this! i am looking for plans for my new hyperpassion game! Do u screw right into the side of the wood on the machine? Also, does anyone know how to play this thing? You akk have an awesome site and im glad i found it!! Also anywhere else to found my next machine besides ebay? Thanks

[Youngjedi]

With the Cabinet I make for my Pachinkos, I explained in the following link How I drilled and secured the machines. There are a lot of other cabinet plans in the members area that you can use.

If you cannot get into the members area, not to worry, it will open up to you as you post more and more.

PachiTalk Research Center - Youngjedi - Pachinko Cabinet - PachiTalk

Enjoy.

[wrkey]

Welcome to PachiTalk HondaChip!

There are many types of cabinets from stand alone to table top to single wall units to multi-machine wall units.

There's several ways to mount your machine in a cabinet, however there are a basic condiserations.

1. These machines are heavy and when loaded with balls can easily reach 35 to 40lbs.
2. When mounted you will need access to either a slot through the back or side to reach the door release, or a key.
3. When mounted and you swing the machine out of it's frame, it creates a huge amount of force on the frame and the cabinet. This must be considered in the design.
4. With modern machines, you will need the ability to load balls quickly as you play so with out a ball lifter you will probably want some type of 'hole' at the top to put more balls in during the fever rounds.
5. Read more in this forum and you find all types of threads about cabinets and the plans to make them.

Good luck and welcome again!

[hondachip]

are the machines still topheavy even with the case?

[Moparformances]

yes there always top heavy a wide base is a good thing if your using it as desk top

simple feet will help u out to get started and or a set of t legs are nice and simple as well

like was stated befor take a few minutes and check out the other posts

[portercbl]

If you are going to build your cabinet out of cabinet grade plywood, such as birch or oak, a 9" width is very stable and works just fine!

Jerry

[mudfud]

check craigslist for local pachinkos. that's where we find the best deals.

welcome!!

[Hope Chest]

If you are going to build your cabinet out of cabinet grade plywood, such as birch or oak, a 9" width is very stable and works just fine!

Jerry

Oh MAN...WHAT A ROOM!!! And those cabinets!!! SO awesome.

Are you looking to adopt a 37-year old? I clean up after myself fairly well.

[portercbl]

Hope, Do you speak Japanese? I need a translator. Then I will adopt! hehehehe

Jerry