Ball Lifter

[compirate]

There's a switch in the bottom rail of the lifter (the one that feeds the toothed wheel) that turns the lifter on when there are balls in it. The paddle switch goes in the upper hopper and turns the lifter off when pushed down. If you plug the unit in and push down on the rail switch with your finger it should turn on.

These are 100-120v units by the way.

[TNTahan]

There's a switch in the bottom rail of the lifter (the one that feeds the toothed wheel) that turns the lifter on when there are balls in it. The paddle switch goes in the upper hopper and turns the lifter off when pushed down. If you plug the unit in and push down on the rail switch with your finger it should turn on.

These are 100-120v units by the way.

In short, put balls in it and see if it does anything!

[rubberratt]

No -

In short. Plug it in. Close the paddle switch, and close the rail switch, and the motor will come on.

[compirate]

No -

In short. Plug it in. Close the paddle switch, and close the rail switch, and the motor will come on.

To be clearer, the paddle is "closed" when it is up, the rail is "closed" when it is down.