Electrical problem

**topcat** · 02-20-2009, 11:25 AM

I have a Pulsar model "Big Chance 777" and from the coin mechanism there is a 5 wire connector. When I pulled it down one of the small wires came loose and is in the connector. Now the machine does not work. What can be done? I can not find anyone that does "Micro" soldering.

**sailorpatp** · 02-20-2009, 11:43 AM

Pictures would help.

You could find the other end of the wires and if that is a plug, remove the wire to take it to someone to solder. Good pictures of the plug ends and how long the wires are would make it easier for someone to see if they might have a spare.

**topcat** · 02-20-2009, 11:47 AM

Picture:

**new in town** · 02-20-2009, 11:48 AM

If there is a "Plug" on each end of the cable, and you can survive some "Down Time" with the machine, Drop me a PM. You can send it to me and I'll fix it for you.

**sailorpatp** · 02-20-2009, 05:51 PM

Looking my WBAR by Yamasa who make the only Pulsars that I know of, It is very different and I don't have any 5 wire plugs to the token acceptor. The thing I did notice is that without power to the magnet the tokens fall right through to the tray. You might be able to put something in to hold the little guide against the magnet and then the Tokens would pass to the counter. They would fall into the hopper even if you had the 50 credits max too.