Error code 2 and continous beeping

[scorpionredstinger]

I have a Sankyo Big Powerful Pachinko that has an error code of 2 and keeps beeping at me even when it is cleared the shooter is not working either I need a manual or some solid advice on this.

I Also have a Twin Vision Not Sankyo but Daiichi that is not always paying out as it should in fact the motor turns a bit then it gives an error code of 3 or 4 I cannot remember exactly but you have to push a button and the balls pay out and then it does it all over again.

Any advice on these would be greatly appreciated!

Thanks in advance.

[Youngjedi]

I had a similar problem with my Indiana Jones Machine. When it needed to pay 9 balls, it would pay 4, then hesitate for 1 second, then pay 5 more. This caused the machine to think it was a ball jam and gave me an error. I took the payout motor out and opened it and cleaned it. now it pays fine...no hesitation.

[Eddie]

Payout 2 error

Cause

Ball jam near payout count switch
Fault with payout count switch
Fault with front tray full switch

Checks

Please check for balls in the payout unit or near payout count switch

Check the connections of the Payout unit cable

Replace payout unit

Replace the payout unit control board

Replace Front tray full switch

[scorpionredstinger]

Tried everything everyone suggested I think I may have a bad motor any way of checking that as well the control board is very complicated. are there any manuals available anywhere.?

[RaymondV]

My Sankyo Casino Fever did the same thing after sitting for several months.
I just took the payout motor off and emptied the balls out and it worked fine after that.
I don't know if that will help.