Azteca - only belly light works

[rjpohl]

I've checked all 5 fuses but the only think that works is the belly light. Any suggestions? I've also tried to find a cable that was loose but didn't. The panel on the top above reel has several small red lights that are lite as well as a panel on the front door that has one red light lite.

any help is needed and aprreciated.
Bob

[alstonj1]

sounds like you lost the power supply . did you buy it this way ? if not what happened before this happened .can you show us some pictures . if the one led on the front that is on is a number the machine maybe in the odds set/reset mode. try doing a hard reset and see if it comes back . turn on the reset key turn off the machine then turn it on , hold down the spin handle for a few seconds then turn the reset key back to normal position . the machine should spring back to life.....

[rjpohl]

the light that is lite is on the inside of the door, not the out side. The machine was working ok then I came back to it later it wasn't.

[luckydog]

check all connections and try a full reset.

[alstonj1]

as i said do a full reset make sure you wait a few minutes when you shut it off then turn it back on in the reset mode . I had a hanabi do the same thing after a thunderstorm (luckly it was on a spike protector) a reset brought it back to life ........trust me i'm a Dr. well at least around here i am ..........check this out im sure youll find it the same
http://www.pachitalk.com/forums/show...t=hanabi+reset

[Arraking]

It sounds like it could be the light board for the top light. Most machines have a small circuit board that will run on or two bulbs at a time. There are two of these in most machines I have seen. If your looking for a direct replacement try Stealth Home Ammusement. Or if your good with electrical try All Electronics for one of there CCFT boards to power the lamp. Of cource providing the lamp is good. If the lamp is a lrger one such as a T5 type about a half inch round, these will not work. But you can get a smaller lamp and board for about $8.00. And provide the power of 12VDC for the lamp and your up and running again!