Star Wars Help!!!!

[hanabi]

Trying to start up my new Star Wars machine!

Firstly think I've got an error code 7 - tried filling hopper but still got the error code

Secondly and most Importantly I can't get past the Start up screen - no footage or anything just showing the Rom code checks?

The shooter however does work - so any ideas ?

all help gratefully received

[hanabi]

bit more detail for you!

Th R2 D2 does its Movements and then stops

The only screen i have showing is the
'CGRom Check Data Screen'
A, B, C, D, E, = OK


On the front of the machine is a Red X light (just above the two blue Circles) does this mean anything?

Also still got the Error Code 7

Driving us mad ! But hopefully it can be fixed!!!

Living in Hope!

[luckydog]

try shutting off the machine and checking all your connections. they get bounced around a lot in shipping.

you should have a reset switch on the back, hold it in for awhile as you are turning the machine on.

Arby may have some pictures of the back in the museum

[hanabi]

Thanks Luckydog Other Half has already done both these things and still no joy!

[luckydog]

Keep playing around with the connections, biggest odds are that is your problem.

can you call any tech support from the seller.

[hanabi]

Yes i have the Suppliers Tech Guys number but he is not available at present ( could be because it's 9-14pm here!)

I will have to contact him tomorrow - just impatient and want to see the machine working!

Fingers Crossed X

[luckydog]

maybe the DR can help you in the chat room

[hanabi]

Hello Again!

Just though I'd post some pictures showing the screen I am getting, also the red X light that appears and the inside of the machine

[musky]

Did you disconnect that cable in the photo???. Is it suppose to be???

[arbycoffee]

YOU ARE UNPLUGED on the back, you can see it in the green back picture

[arbycoffee]

One is off and the other is loose

[birdbrain]

i think shes just trying to see if your smart enough!!

[hanabi]

Actually we did notice it!

But I told O.H. 'DON'T TOUCH ANYTHING' till I've checked it with you guys!

Unless I can find a Screwdriver I'll have to wait till O.H. gets home from work!

Why Can't you lot move closer!!!

[hanabi]

Well that connector is sorted now!

we have Star Wars, lights & Sounds

but still have the error code 7 to sort

[DrDark]

Is this a DONGLE issue?
Is your dongle connected?

[Bencrest]

You say you have filled the hopper - but looking at the back of the machine, are the balls in an uninterrupted path down into the ball mechanism, or are they stopped by something?

You may find theres a 'clip', made of metal, which is laid flat, and the prongs from it are stopping balls from running into the mechanism. You will be able to pull the clip, with the 2 prongs on, vertically upwards and out of the way. It'll be located on top of the two parallel channels which run from the underside of the hopper, to the opposite side of the machine, at the side opposite the hopper.

NOTE - make sure you have a token tray or something similar to catch any balls at the back of the machine.

[Chris]

Hopefully now sorted & working

[hanabi]

Yes! the Force is deff with us.....

and I'd just ;like to say a special thanks to everyone who helped, especially Chrish and the Doc!!!

[hanabi]

Just to prove the Star Wars is runnng

here she is


Star Wars Cabinet Hopper 001 resized.jpg

[Chris]

Cool & cabinet looks nice as well