Pageing arby or anyone else with cr fireworks

[drcrippen324]

Well iv been laid up ill for a few days and my new toy Crfireworks arrived on friday so i finaly get of my death bead and get the energy together to put legs on it ect and it wont pay out iv looked at the payout setup and it has moved along with the hole back of the machine of the plastick hinges i have tried to lift it back (gentaley) but to no avai are there any screws holding it together or clips or somthing im missing if any one can help i would be grateful and i can supply pics

[Tulsa]

You probably have a ball jam in the counter. Look down the side where the balls are fed and look for a plastic box, probably clear, that has a cog in it. Open this and check to make sure the cog is seated properly.

[drcrippen324]

no definatly not ball jam there are five of these hinge type things tree down one side two down the other witch due to the city link monkey that delivers to me have all jumped out of there holes putting the hole payout track out of line but i cant find what releases the plastic cover to be able to lift the hole thing back on its hinges

[Tulsa]

Maybe an over all shot, some tighter shots and either that's out of focus or it's time for an eye exam.

[johntofva]

With the hopper full of balls, pull the ball release. The balls should flow all the way through to the bottom.

[drcrippen324]

ok peeps thanx for replies but whilst waiting i started to get stuck in and you know how you get so far that you are kinda stuck till you finished well thats how i ended up about 20 screws later some creaking of plastic and almost dropping a 20inc lcd off a table i got it cured will post the pics encase anyone gets the same problem

ok heres the pics hope you can make sence of them but if you get the same problem yell me and il make them a bit better if i can oh and if you have to do this make sure the glass is closed on the front or the monitor becaumes very loose

[arbycoffee]

That is a cover to the computer and swings out to your left hand. that is the top hing point.
six screws to remove to open it up and at perpendicular you can reconnect the top hinge pin. this cover has nothing to do with your ball track it is on the left side.

I will post some info later after I get some pictures done.

[arbycoffee]

fireworks ball track

[drcrippen324]

thanx arby i did get the problem solved what had happened was the computer cover hinge had come off and was attached to the cover/ball track on the left and inturn un hinged that i could see how to swing out the ball track but only if i released the computer cover but i explained it badly as i didnt know my way around fireworks at the time but noe i have the equivalent to a map and will be able to refer back for future help thanx again buddy

[scooby_doo_m2002]

is that what a parlor ready machine looks like in the back?

[luckydog]

Yes, palour ready.

note Arby's sturdy bottom stand and heavy duty transformer.

Quality all the way

[drcrippen324]

yep the recerculating look almost the same they still have ball track and payout mech but deep in the workings the ball track is altered so as to spew used balls to the shooter tray and not payout balls so the hopper at the top never has to be filled
oh and the hopper empty censer is bypassed

may i add that is a very clean and fine example
but hey what else would you expect from arby

[arbycoffee]

Sorry I was late